ETERNUS Nagios Plug-in is software to monitor the ETERNUS AF/ETERNUS DX on Nagios XI.


Requirements for hardware and software are listed below.

Supported Storages All-Flash Arrays ETERNUS AF150 S3
ETERNUS AF250 S3/S2, AF250
ETERNUS AF650 S3[1]/S2, AF650
Hybrid Storage Systems/
Disk Storage Systems
ETERNUS DX100 S5/S4/S3, DX200 S5/S4/S3
ETERNUS DX500 S5[1]/S4/S3, DX600 S6/S5[1]/S4/S3
ETERNUS DX900 S6/S5[1]
ETERNUS DX8100 S4[1]
ETERNUS DX8700 S3, DX8900 S6/S4[1]/S3
ETERNUS DX400 S2 series
ETERNUS DX8000 S2 series
Supported Platforms Red Hat Enterprise Linux 8 (for Intel64)
Red Hat Enterprise Linux 7 (for Intel64)

[1] Firmware V11L30 or higher is required.


Download is free.
For use of ETERNUS Nagios Plug-in (hereinafter called "this software"), Fujitsu requires that you agree with the following "Conditions of use". Using this software means the following conditions are agreed, so please desist from downloading if you don't agree.

Conditions of use

Please ensure that the following usage conditions are met when using this software.
Do not use this software if you cannot observe these use conditions.

  • This software can be used only with the target model(s).
  • This software cannot be redistributed.
  • You may not reverse engineer, decompile or disassemble the software.
  • Any copyright mark concerning this software may not be revoked.
  • Any damage occurring following use of this software is at your own risk, Fujitsu will not assume any responsibility for operational problems.

Version File name File size Release Date
1.7.0 ETERNUS Nagios Plug-in
md5 checksum: 3286aa9d432d43ea74b7b5f8c9db9446
213KB May 15, 2024
User's Guide
820KB May 15, 2024

How to download and install

  1. Download the file onto your computer.
  2. For settings and important information, refer to "User's Guide".