Hardware-Evaluation Boards
Glyn GmbH & Co. KG
| GlYN offers several low cost Evaluation boards for 16LX Flash mcu and graphic controller. Depending on the board variant, delivered with Software and Appnotes connecting Memcards, GSM, GPS, Displays, etc. Support Hotline via E-Mail. | |
 |
Glyn GmbH & Co. KG Am Wörtzgarten 8 65510 Idstein / Ts. Germany Tel: 06126-590-234 Fax:06126-590-155 MCU@Glyn.de www.Glyn.de |
| hke gmbh | |
| HKE gmbh released the new tempest Fxxx series: Single board computers in bank card format for development phase and serial products: Equipped with the MB90F387, F428, F443, F462, F497, F543, F553, F562, F568, F583, F591 or F598 mcu, reset, eeprom, buzzer and integrated bootloader. The tempest Fxxx+ series are available with additional 1MByte Flash and 256KByte battery buffered RAM. Easy and fast firmware with the host interface. First evaluations steps are quickly done with the evaluation board! Find more details and prices on our homepage: www.hkegmbh.com! |
|
 |
hke gmbh Voggenberg 11 A-5101 Bergheim Austria Tel: +43/662/458117-5 Fax:+43/662/458117-8 embeddedcontrol@hkegmbh.com www.hkegmbh.com/ |
| PHYTEC Meßtechnik GmbH FUJITSU 91F364 Modul |
|
| The Fujitsu 91F364 modul supports the Fujitsu M91F364G microcontroller. This device has a host of on-chip peripheralsincluding UARTs, I²C and serial synchronous interfaces, in addition to the CAN interface, 16 bit reload timers, input-capture/outputcompare units and real time clock, as well as a 12- channel ADC and 8 external interrupts. This wealth of peripherals is supported by the Fujitsu 91F364 modul. All signals extend to standard-width (2.54 mm.) pin rows aligning two edges of the board. Additional DB9- connectors, a power connector and 5 LEDs allow use of the board without a development board. Particularly important is the DB9-serial connector which enables easy use of the new on-chip ‘background debug support unit’, which helps software development and debugging of the final application without the use of in-circuit emulator systems. This unit provides a number of instruction and data-breakpoints including mask and range-functionality. Together with the appropriate background software, this unit speeds up application development and offers the ability to debug in the final application. The second DB9- connector allows connecting the board to a CAN-bus. | |
 |
PHYTEC Meßtechnik GmbH Robert-Koch-Str. 39 D-55129 Mainz Germany Tel: +49-6131-9221-0 Fax:+49-6131-9221-0 info@phytec.de www.phytec.de |
