Skip to main contentSkip to menu

FUJITSU

Main contents start here

MB96330 Series : MB96F338RSAPMC

SERIES KEY FEATURES

CAN (3ch), LIN (8ch), ADC (40ch), 56 MHz

DESCRIPTION

MB96330 series is based on Fujitsu’s advanced 16FX architecture (16-bit with instruction pipeline for RISC-like performance). The CPU uses the same instruction set as the established 16LX series - thus allowing for easy migration of 16LX Software to the new 16FX products. 16FX improvements compared to the previous generation include significantly improved performance - even at the same operation frequency, reduced power consumption and faster start-up time.

For highest processing speed at optimized power consumption an internal PLL can be selected to supply the CPU with up to 48MHz operation frequency from an external 4MHz resonator. The result is a minimum instruction cycle time of 20.8ns going together with excellent EMI behavior. An on-chip clock modulation circuit significantly reduces emission peaks in the frequency spectrum. The emitted power is minimised by the on-chip voltage regulator that reduces the internal CPU voltage. A flexible clock tree allows to select suitable operation frequencies for peripheral resources independent of the CPU speed

Top of Page

BLOCK DIAGRAM

MB96330

Top of Page

PRODUCT FEATURES

Specification Description
CPU [Bits] 16
Package FPT-144P-M08
Pincount 144
Flash memory 544.00 KByte
Flash Security (read protection) yes
RAM (code & data) 32.00 KByte
VCC min 3.00 V
VCC max 5.50 V
Min. Temperature -40 °C
Max. Temperature 105 °C
Max. CPU frequency 48.00 MHz
Clock Supervisor yes
DMA channels 8
Max. I/Os 124
A/D Converter 1
A/D channels 40
A/D resolution 10 bit
A/D conversion time (min.) 1.700 µs
LIN-USART 8
CAN 3
I2C 2
Programmable Pulse Generator (PPG) 20
Output Compare Unit (OCU) 12
Input Capture Unit (ICU) 10
IOTimer 4
Reload Timer 4
Timebase Timer (TBT) 1
Real Time Clock (RTC) yes
Watchdog 1
Alarm Comparator 2
Low Voltage Detection (LVD) yes
External Bus yes
External Bus mode Multiplexed, non-Multiplexed
Chip-Selects 6
External IRQ 16
CAN Message Buffers 32

Top of Page

DOCUMENTATION


Top of Page

STARTERKITS

Top of Page

DEBUGGER and EMULATOR

In-Circuit-Debugger

Starterkit A

Starterkit B

Starterkit C

  • Power Supply Unit for Starterkit
    POWERED BY USB

  • Starterkit

    SK-16FX-144PMC-USB

Top of Page

(FLASH-)ROM Programming Tools

  • CONITEC GALEP
    serial
    Conitec 210865/210915

  • CONITEC GALEP
    parallel
    Conitec 210896

  • FLASH_PROGRAMMER_16FX

    serial (async)

Top of Page

SOFTWARE EXAMPLES

The following software is for demonstration purposes only. It is not fully tested, nor validated in order to fulfill its task under all circumstances. Therefore, this software or any part of it must only be used in an evaluation laboratory environment.

All software examples

Top of Page

APPLICATION NOTES

Please find a selection of Application Notes here or check the complete overview:

All application Notes



Top of Page

Related menu starts here

Main menu starts here
End of the page