M2611T#D and M261 ET Series Jumper Setting
Obsolete product information
M2611T#D, M2612ET, M2613ET, M2614ET
PCA Layout
All configurations marked * are default settings.
1. SW1
| 1. IRQ14/RSVD | ||
|---|---|---|
| Normal status | Key 1 ON (*) | Key 2 OFF (*) |
| Pin 29 = Reserved | Pin 31 = IRQ 14 | |
| After exchange | Key 1 OFF | Key 2 ON |
| Pin 29 = IRQ 14 | Pin 31 = Reserved | |
| 2.SLV/ACT | ||
| Normal status | Key 3 OFF (*) | Key 4 ON (*) |
| Slave present mode | Key 3 ON | Key 4 OFF |
Note: This plug should be set in "Active mode" on daisy-chained connection of both M261xET.
2. SW2
| 1.Master / Slave | ||
|---|---|---|
| Master drive | Key 1 ON (*) | Key 2 OFF (*) |
| Slave drive Slave side of 2-drive system |
Key 1 OFF | Key 2 ON |
| 2. 1-drive / 2-drive | ||
| 1-drive | Key 3 OFF (*) | |
| 2-drive | Key 3 ON | |
| 3.Write-protect | ||
| Write-enabled | Key 4 OFF (*) | |
| Write-protected | Key 4 ON | |
| 4. IOCHRDY | ||
| 1-drive | Key 5 OFF (*) | |
| 2-drive | Key 5 ON | |
| 5.ECC Bytes | ||
| 4 bytes | Key 6 OFF (*) | |
| 7 bytes | Key 6 ON | |
3. Connector CN7
External LED connection
e: Cable length should not exceed 30 centimeters.
| Pin | Signal |
|---|---|
| 01 | LED(V) |
| 02 | LED |
