Network Virtualization Node Software works on generic IA servers and provides U/C-plane separation(*1) in response to SDN trends in wide area networks. This software provides VPN features (L2 over L3 tunneling & forwarding) and resource virtualization (slicing) of wide area networks.
(*1) The technology which processes User-Data(User Plane) and Control-Data(Control Plane) separately
(*2) One of the centralized network controls, which is standardized by ONF(Open Networking Foundation)
This software provides network virtualization of wide area networks on generic IA servers. Therefore, network service providers are able to construct network systems which can reduce CAPEX/OPEX in use cases such as inter Data Center networks, M2M networks, control plane networks, etc.
(*3) Pairing this software with the wide area virtual network operational control and management software, Virtuora NC, enables the network to operate cost-effectively
Visualization and traffic optimization using SDN centralized control
It is possible, using SDN centralized control, to visualize and optimize the configuration of traffic routes over Virtuora SN-Vs deployed throughout a network. This is achieved by designing and setting routes according to the various traffic characteristics of M2M applications. These characteristics are based on operational policy per telecommunications carrier.
Multi-tenancy of networks with widely deployed sites
By configuring L2 over L3 tunneling for each tenant in Virtuora SN-V between each Site, it is possible to provide a virtual network service in a wide area network and to operate the physical networks bandwidth efficiently
Integration of wide area networks
By integrating wide area networks of other carriers into Use Case 2 and operating its customer network as a single network, it is possible to further reduce the OPEX of each customer.
|CPU||Intel® Xeon® Processor (4 CPU cores) or faster processor|
|Memory||12GB or greater|
|Disk||200GB or greater|
|Ethernet Card||10 / 100 / 1000BASE-T x2 or greater|
|Other requirements||SAS array controller card|
|Red Hat Enterprise Linux 6.4 (for Intel64)|
(*4) Supported platform: FUJITSU Server PRIMERGY Series (since May, 2014)
Share this page