RECOVERY PROCESS

Note:

• Always backup your important data before perform the recovery.
• Format and recover option will erase your hard disk content including data files. Choose Recover without format will not erase your hard disk content.
• Do not perform recovery unless the 操作系统 encounter critical errors.
• You may use Composite/Driver CD to reinstall device driver or pre-installed program during or after the recovery process.

For Windows XP

Note:

• Always backup your important data before performing the recovery.
• Format or initialize hard disk will erase all your hard disk contents including data files. Do not use this option unless absolutely neccessary.
• Do not perform recovery or reinstallation unless the Windows 操作系统 encounter critical errors.
• You may use Composite/Driver CD to reinstall device driver or pre-installed program after the recovery process.

For Windows XP Tablet PC Edition

Additional notes for system without a Tablet Dock:

If your system does not come with a Tablet Dock, you can use either of the following methods to perform recovery.

• Hard disk second partition
• USB CD-ROM
• PCMCIA CD-ROM

Always uses hard disk second partition as first choice as it does not require any additional hardware. However, if you does not have a second partition or a Tablet Dock, you may perform recovery using other methods.

Setup Instructions for using Fujitsu USB CD-ROM/RW drive to perform recovery from CD ( for model without a Tablet Dock )

Requirements:
i) USB Boot floppy 驱动器
ii) USB keyboard
iii) USB CD-ROM

Since ST4110 only has 2 USB ports, only 2 USB devices can be used at one time. At initial setup, use your tablet PC navigation key ( to make selection ) and enter button to simulate key press.

1. Connect only the USB boot floppy and USB CD-ROM at either ports
2. Boot up system using Tablet PC Recovery boot floppy
3. Use navigation button to select RECOVER USING FUJITSU USB CD-ROM or other USB CDROM
4. Press enter Button (ent) at your tablet PC when prompted to press Entere)
5. Windows installation continues by copying the filesf)
6. Observe when file copy is going to complete ( at about 95% ), and after copy finish, unplug USB boot floppy immediately and plug in the USB keyboard. From there onwards, use the USB keyboard.

If you have an IR Keyboard
Above step is not necessary if you have an IR keyboard as IR keyboard does not occupy any USB port.

Using other third party CD-ROM
If you have other third party CD-ROM, replace your CD-ROM DOS device driver in the following line in config.sys

DEVICE=A:\USBCDROM\USBCD.SYS /D:OEMCD001