DESCRIPTION

To install the Software Sample Files please download the compressed self-extracting file. The Standard Installation Target Directory is:

C:\Softune\sample\smpl16

FEATURES

• ADC Project:
  This is a simple demo program to use the A/D converter.
• Boot Loader:
  This project contains a boot strap loader. It can be used to create application specific bootloaders.
• CAN:
  CAN0 and CAN1 will send out a counter-value. The lower nibble of the received data of CAN0 (basic Can) will appear at Port P00..P03 (UserLEDs D1-D4 of Eva-Board Flash-Can-100P) The lower nibble of received data of CAN1 (basic Can) will appear at Port P04..P07 (UserLEDs D5-D8 of Eva-Board Flash-Can-100P) If CAN0 and CAN1 are connected together at the Flash-CAN100P Eva-Board, the 4-bit-countervalue is visible at LEDs D1..D4 / D5..D8
  CAN0 Buffer #1: basic CAN ("receive buffer")
  CAN0 Buffer #6: full CAN ("transmit buffer") => sends with ID#1
  CAN1 Buffer #1: basic CAN ("receive buffer")
  CAN1 Buffer #6: full CAN ("transmit buffer") => sends with ID#2
• CANmanag:
  tiny CAN Management (requires Softune IDE >= SoV30L27): This is a demoprogram for to a simple network management for CAN. Up to 32 nodes can be configured. Each node connects automatically to the network. All nodes make a logic ring.
• CAN_Uart:
  The CAN_UART example show functionality of the CAN-controller. The program is controled by a PC-terminal-program (9600Baud)
• IOPORT Project:
  IOPort-project simply counts down an internal variable and outputs the counter value to port1. No interrupts are used.
• OCU590 Project:
  The project OCU590 is intended for use with the MB90590 Microcontroller. It's an easy example how to initialize the Output Compare Units (OCU).
• PLL_off Project:
  This is a simple demo project to switch off the PLL and select the main clock.
• PPG Project:
  Interrupt service routine of Reload-timer0 is used to modify PPG channel 1.
• Reload Project:
  Reload-project uses interrupts of reload-timer0 and reload-timer1 to toggle LEDs.
• Sound Project:
  This is a simpel demo project to initialize and use the sound generator.
• Step Project:
  This is a simple demo project to initialize and use the stepper motor controler.
• Template Project:
  This is a project template for the MB90590 Series. It includes some basic settings for e.g. Linker, C-Compiler which must be checked and modified in detail, corresponding to the user application.
• UART0 Project:
  This is a simple demo program to initialize and use the UART interface.
• WatchTimer:
  This project sample shows, how to initialise the Watch Timer. The Time is set to 00:00:00 and started. No interrupts are used to change the hours, minutes and seconds register. The WatchTimer output (WOT) is enabled and outputs every reload of the second register an highpulse of 50us.
• History of the MB90590:

DOWNLOAD

Note: Netscape Navigator 4.xx does not allow direct execution of ".exe" files. Saving them to a temporary folder and executing them there is recommended.

EXESelf-extracting Sample Files for MB90590 Series V01R10 (868 KB, 11.September 2006)